GoKarters.Com ___Hobby Forum  
QRZ callsign lookup:

Go Back   GoKarters.Com ___Hobby Forum > Over The Air > Home Brew And Tech Forum
FAQChatBox Full Members List Calendar Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Rate Thread Display Modes
  #1  
Old 03-07-2010, 07:24 PM
KC4UMO's Avatar
KC4UMO KC4UMO is offline
Administrator
 
Join Date: Apr 2000
Location: Greenville NC
Posts: 2,594
KC4UMO is on a distinguished road
Default 700 watt homebrew dummy load

Today I needed another dummy load for the other repair bench.
Went to lowes and picked up a 1 quart paint can.
For this project you will need:

1-1 quart paint can
1 SO-239
2-1 inch by 4 inch copper circuit boards
14 680 ohm 5 watt carbon resistors
4 4-40x12 machine screws and 5 nuts
1 small terminal ring
1 quart mineral oil
A few inches of stiff hook up wire
silicon sealer


Mount SO-239 in top of paint can.

Tape the 2 circuit boards together and drill 14 even spaced holes to pass the resistor leads.

Install the 14 resistors in one side of circuit board. Copper side out. Leave about 1/8 of an inch between board and resistor. Cut leads and bend over. Solder all leads

Install other side same as previous.

At this time with an ohm meter check from one plate to the other. See how close to 50 ohms you are. If you need add or subtract resistors. With 14 installed mine was 50.7 ohms. This will depend on how close the tolerance of your resistors are.

Install the small ring terminal to one of the SO-239 mounting bolts pointing out. Bend it so it points away from lid.

Next cut 2 1 1/2 inches of stiff hook up wire. Solder one to the center of the SO-239 and the other to the terminal ring . Bend wire out and then down so it is the same OD as your resistor board.

Next mount resistor board as close to the lid as you can by soldering the two wire to it.

Insert in can and check SWR with a few watts. All should be good as this point.

Remove lid and seal the bottom of the SO-239 and the 4 mounting screws.

Take a break. You deserve it. Got to let silicone dry anyway.

Come back and fill can with mineral oil leaving about 3/4 inch from top.
Re-install lid and press in good

If you have 14 resistors installed you now have a dummy load that will handle 70 watts dry for short periods. I see know reason why it will not handle 700 watts in oil.
I will do the math later to figure out watt it will handle later unless someone else wants a stab at it.
Attached Images
   
__________________
Buddy

KC4UMO

My Web Site
Reply With Quote
  #2  
Old 03-08-2010, 01:16 PM
KC4UMO's Avatar
KC4UMO KC4UMO is offline
Administrator
 
Join Date: Apr 2000
Location: Greenville NC
Posts: 2,594
KC4UMO is on a distinguished road
Default

The finished product.
Attached Images
  
__________________
Buddy

KC4UMO

My Web Site
Reply With Quote
  #3  
Old 03-08-2010, 11:27 PM
JADE JADE is offline
Platinum
 
Join Date: Sep 2004
Location: San Diego
Posts: 369
JADE is on a distinguished road
Default

Hey, who did you put in that can, Reid or Pelosi?
__________________
God bless,
JADE

********************************
I question....therefore I think....I think....therefore I am....I think?
Reply With Quote
  #4  
Old 03-09-2010, 08:10 AM
KC4UMO's Avatar
KC4UMO KC4UMO is offline
Administrator
 
Join Date: Apr 2000
Location: Greenville NC
Posts: 2,594
KC4UMO is on a distinguished road
Default

Quote:
Originally Posted by JADE View Post
Hey, who did you put in that can, Reid or Pelosi?


I will never tell!
Attached Images
 
__________________
Buddy

KC4UMO

My Web Site
Reply With Quote
  #5  
Old 03-09-2010, 08:32 PM
crazy's Avatar
crazy crazy is offline
Moderator
 
Join Date: Mar 2004
Location: Dixie
Posts: 604
crazy is on a distinguished road
Send a message via Yahoo to crazy
Default

Quote:
Originally Posted by JADE View Post
Hey, who did you put in that can, Reid or Pelosi?
There isn't a can in the world that could hold those two worthless windbags..............
__________________
Peace will not be found at a MidEast table. Peace began at a MidEast STABLE, but everyone seems to deny it.
We can easily forgive a child who is afraid of the dark; the real tragedy of life is when men are afraid of the light.
Believing in evolution is like expecting a tornado to go through a junkyard and create a Mercedes Benz on its way out!
If you don't stand behind our US troops, then please feel free to stand in front of them. Yea, that's what I thought..........
Reply With Quote
  #6  
Old 03-09-2010, 09:34 PM
JADE JADE is offline
Platinum
 
Join Date: Sep 2004
Location: San Diego
Posts: 369
JADE is on a distinguished road
Default

Quote:
Originally Posted by crazy View Post
There isn't a can in the world that could hold those two worthless windbags..............
Then that breaks the truth in advertising law. It says it is loaded with dummies.
__________________
God bless,
JADE

********************************
I question....therefore I think....I think....therefore I am....I think?
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 05:35 PM.


Powered by vBulletin® Version 3.6.5
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Shower Chairs
Shower Chairs